I built five jigs for the table saw using Bow Featherboards. These jigs give you lateral pressure against the fence but also vertical pressure down toward the table top. This ensures that the stock you are cutting remains flat against both the fence and the table. This gives you extremely accurate cuts. Below is a list of products I used for this build.

5 Jig Plan Bundle - https://www.731woodworks.com/store/tablesawjigs

Watch the build video and see the jigs in action https://youtu.be/I-_Yt1787Bw

Use codes the following coupon codes to save 10% on Bow, MicroJig, and MagSwitch products at TayTools linked below.

• 731BOW10

• 731MAGSWITCH10

• 731MICROJIG10

Amazon and TayTools affiliate links are used in this post to help support our website.

Products

• Large Bow Featherboard - https://lddy.no/1cq5n

• Small Bow Featherboard - https://lddy.no/1cq5o

• 5/16” Hardware Kit - https://lddy.no/1cq5r

• 1/4” Hardware Kit - https://lddy.no/1cq5q

• MagSwitch 2-Pack - https://lddy.no/1cq5s

• Dovetail Clamps 2-Pack - https://lddy.no/1cq5t

• Dovetail Router Bit - https://lddy.no/1cq5u

• Matchfit Hardware Kit - https://lddy.no/1cq5v

• T-Track - https://lddy.no/1cq5x

• Double Stick Tape - https://lddy.no/1cq5y

• CA Glue - https://amzn.to/3RJ0KZf

The MagSwitch requires a 40mm or 1 5/8” hole. 40mm fits best but 1 5/8” works too, they’re just slightly smaller than the hole. But when you screw them in, it really doesn’t matter. Two options for bits below.

• 40mm Fortsner Bit (for the MagSwitch Holes - https://amzn.to/3QxUCRP

• 1 5/8” Fortsner Bit (for the Magswitch Holes) - https://amzn.to/3RLeeTJ

Other Tools I Used in this Build

Combination Square - https://amzn.to/3D4EjsJ

Small Tri-Square - https://amzn.to/3CZ4Zv4

My Favorite Tape Measure EVER - https://lddy.no/1cpwh

Related Articles:

Best Table Saw for Beginners

SawStop Compact Table Saw Review

First 5 Power Tools for Beginner Woodworkers